Tag: drill
Make Wooden Beads Without A Lathe.
by Lathe on Jan.28, 2010, under Lathe Videos
Here is a simple way to make your own wooden beads any size up to roughly two inches diameter without using a lathe. Visit my web site for all the details: www.stevengarrison.com
Popularity: 3% [?]
Jacobs #100 Armature Chuck For Metal Lathe
by Lathe on Jul.04, 2009, under Lathe Videos
This is a very rare, special purpose, Jacobs Chuck. This is a #100 Jacobs chuck 1/4 to 3/4 its mounted with a #2 Morse taper to a #33jacobs taper arbor with brass/bronze jaws. This is a shaft centering chuck for turning generator and starter armatures that are not drilled for normal centers. The correct name for it is centerless armature turning chuck. Nice piece and not to common as only automotive shops bought them. It is used by having an armature locked in the large Jacobs drill chuck …
Popularity: 2% [?]
Wood Turning Basics – Lathe & Tools 2 of 2
by Lathe on Jun.25, 2009, under Lathe Videos
Beginning wood turning. A look at lathe tools and a cutting exercise.
Popularity: 1% [?]
Peck drill (very small holes on the lathe)
by Lathe on May.08, 2009, under Lathe Videos
A device I designed and built to aid in the drilling of very small diameter holes on my 9×20 lathe without breaking the drill bit! The original idea was formed after watching a video by Gmark1953 ‘drilling an orifice on the lathe’ I just thought the holding of the pin vice a little risky!
Popularity: 3% [?]
-
Welcome to HandLathe.com - Lathe Products and Blog!
Thanks for dropping by! Feel free to join the discussion by leaving comments, and stay updated by subscribing to the Lathe Forum.
